Pull the throttle lever, located on the handle of the lawnmower or the body of the engine, into a mid-to-high position. Grab the starter cord handle and pull it upward quickly and firmly. You may have to do this several times before the motor starts up.
How do I free up the throttle cable on my lawn mower?
If your lawn mower’s throttle cable is hard to move or stuck, here’s a fix. Disconnect both ends of the cable from the mower. You’ll probably have to remove a bolt and disassemble the lever assembly near the handle to get the cable out. Take a digital photo to help you put it back together when you’re done.
Why does my lawn mower not throttle?
If your lawn mower will idle, but stalls on throttle, check the muffler and carburetor. … If your lawnmower will start up and idle, but then dies when you throttle it up, you might have a problem with the carburetor. The carburetor brings air and fuel together and mixes them in a perfect ratio for combustion.
How does a lawnmower throttle work?
When you are running the lawn mower at full throttle, the engine is moving faster which makes the blades rotate faster and that will allow the blades to make a nice clean cut giving your lawn that perfect finish. At a lower throttle the blades will spin slower which may result in a more disheveled or uneven blade cut.
How much does it cost to fix a stuck throttle?
When the throttle body fails, the engine won’t be able to remove the right mixture and will start to experience problems. To replace your car’s throttle body, you will pay as little as $370 or as much as $1,500. Labor should be between $70 and $260, and parts should cost you from $110 to $600.
What would cause throttle to stick?
A sticky throttle could be caused by worn cables, lack of lubrication in the cables or the cable getting bound up somewhere in the mechanism. Or it can be caused by an issue with the carburetor or EFI. … If the screws in the throttle housing are too tight it could cause the cable to stick.
How do you fix a sticking accelerator?
When you get at the butterfly valve, you will probably see a lot of gunk, which could be the culprit behind the sticky gas pedal. To remove the muck, spray some throttle body cleaner on and around the butterfly valve and use a cloth or soft-bristled brush to rub it away.
Should I run my mower at full throttle?
Run it at full throttle
A: Absolutely–and in fact, you should! … Lawn equipment (including lawn mowers, lawn tractors, and even trimmers and blowers) is designed to run at full throttle to give the best performance. Your blade will turn faster at higher throttling, which is essential to proper cutting.
What is throttle in lawn mower?
The throttle is a component of the lawnmower that controls the speed of the engine. The throttle is used when starting the engine and during mowing to regulate fuel consumption and the speed which the blades turn.
How do I fix a small engine surging?
Problems in the Fuel System
Check and clean the vent. Surging is also caused by water that got into the fuel. A mower left in a heavy rain or condensation on a hot summer day can choke the engine. Empty the gas tank, properly dispose of the old fuel and try a fresh batch of gasoline.
How do you adjust the governor on a lawn mower?
To adjust the governor, you would loosen the screw on the bottom of the governor arm and push the governor arm so the throttle is wide open. Then you would turn the bottom “clip” (which is connected to the governor shaft) counter clockwise. This will set the governor shaft on top of the governor spool.